How to Make Perfect Paper Daisies – Step by step

How to make Paper Daisies step by step DIY tutorial instructions, How to make step by step picture tutorials DIY instructions Craft.

For a daisy, we need four dyrokolnyh flower. Dyrokolny flower my biggest – 3.5 cm pasted four flowers in each other. The next step – from the smallest flower dyrokolchika (1.5 cm), just attach the petal shape (a little uncomfortable, too small) and cut in half. Take it pintsetikom, Macao and glue sadim in nest helping toothpick seat. I first six halves of the plant, and then be sure that enough for five. Next, cut into length of 24cm yellow stripes. and a width of 5mm. (I folded it in half, so quickly cut) I paper of 130g.

In the hardware store bought wire cord for garters colors. More bites and, in general – a find!

Nakusala delays in a beautiful wrapper, and went to work. Bared wire twists forceps
bodied roll and flooded adhesive (two drops included). I did just 30 pieces.

When the glue has dried, adhesive planting green floret on average Punch (2.5 cm)
glued to various embodiments of reducing 5 petals. Decided it’s better as it is – 8.
One zagotovochku glued on sepal, one at a flower and gave dry (1 min.), Then glued together.

And it leaves for chamomile. Daisies are so many different varieties and leaves. I chose this brand.
On the holes do not pay attention. I first, skeletons pinned and he broke down at this point.

Cardboard density 270gr. Width 1.5 mm strips. Again, use a hole punch of medium size (2.5 cm.)

Take a leaf tip tweezers and glue Mara.

Joints skeletons, I also covered leaf.

I think that would look good.

Pin for later!

Hope you like this Paper Daisies Flower Tutorial.

DIY: Recycled Newspaper Temple at Home -Mandir for Pooja

You may also like...

Related Craft Ideas

Leave a Reply

Your email address will not be published. Required fields are marked *